Amana Washer Error Codes | AppliancesCare

Found Your Error Code?

Our technicians serve Miami, Hialeah, Doral, and surrounding areas — same day. Call now for fast diagnosis and repair.

📞 Call (786) 587-0722

📋 Error Code Index — Amana Washer

F0E2 Overloaded Drum F3E2 Outlet Thermistor Fault F5E1 Door Switch Fault F8E1 Water Supply Fault

F0E2

Overloaded Drum

Drum load exceeds the rated capacity — motor drawing excess current or imbalance detected.

Low Priority

Possible Causes
Too many items loaded into drum at once
Single heavy item creating extreme imbalance
Wet items clumped together on one side of drum
Diagnostic Steps
1Cancel cycle and remove several items from drum
2Redistribute remaining items evenly around drum
3Restart cycle — follow manufacturer load size guidelines

F3E2

Outlet Thermistor Fault

Water outlet temperature sensor open or reading outside expected operating range.

Medium Priority

Possible Causes
Thermistor failed open or shorted internally
Connector to thermistor loose or corroded
Diagnostic Steps
1Inspect thermistor connector for corrosion or loose fit
2Test thermistor resistance — value should vary with water temperature
3Replace thermistor if reading is open (OL) or near zero ohms

F5E1

Door Switch Fault

Door lid switch not confirming closed position — cycle cannot start or continue safely.

Medium Priority

Possible Causes
Door lid not fully closed or latching correctly
Door switch failed internally — not signaling closed
Wiring to door switch open or damaged
Diagnostic Steps
1Push door firmly closed — listen for click of latch engagement
2Inspect latch and strike for damage or misalignment
3Test door switch continuity — replace if open when door is closed

F8E1

Water Supply Fault

Washer not detecting water flow into drum — fill timeout reached without adequate water level.

Medium Priority

Possible Causes
Water supply valves closed or partially closed
Inlet hose screens blocked with mineral deposits
Inlet valve solenoid failed — not opening on demand
Low household water pressure below required minimum
Diagnostic Steps
1Verify both hot and cold supply valves are fully open
2Disconnect inlet hoses and clean screens of mineral deposits
3Check household water pressure — minimum 20 psi required
4Test inlet valve solenoid resistance — replace valve if solenoid failed

Need a Technician in Miami or Hialeah?

AppliancesCare provides same-day Amana washer repair across Miami-Dade. Bilingual service — English & Spanish.

📞 Call (786) 587-0722

Important Notice: Washer error code information on this page is based on Amana manufacturer service documentation. Always disconnect power and water supply before inspecting internal components. Fault behavior and diagnostic steps may vary by model and production date. When in doubt, contact a certified appliance technician. AppliancesCare Appliance Repair LLC provides this information for educational purposes only.