Bosch Oven & Stove Error Codes

Found Your Error Code?

Our technicians serve Miami, Hialeah, Doral, and surrounding areas — same day. Call now for fast diagnosis and repair.

📋 Error Code Index — Bosch Oven & Stove

E001Oven Temperature Sensor Open E002Oven Temperature Sensor Short E003Cooling Fan Fault E010Door Lock Fault E011Control Board Fault E031Self-Clean Overtemp

E001

Oven Temperature Sensor Open

RTD probe open circuit — oven cannot monitor temperature

Medium Priority

Possible Causes
RTD probe failed open
Connector loose or corroded
Probe wiring open
Diagnostic Steps
1Test probe resistance — ~1080Ω at room temp
2OL reading confirms failed probe
3Reseat connector before replacing
4Replace oven temperature sensor

E002

Oven Temperature Sensor Short

RTD probe shorted — incorrect temperature reading to control board

Urgent

Possible Causes
RTD probe failed shorted
Probe wiring touching oven cavity
Diagnostic Steps
1Test probe — near 0Ω confirms short
2Inspect probe wiring
3Replace sensor — do not operate until repaired

E003

Cooling Fan Fault

Cooling fan not operating — overheating risk to control board

High Priority

Possible Causes
Fan motor failed or seized
Wiring to fan open
Fan blade obstruction
Diagnostic Steps
1Check fan blade for obstruction
2Test fan motor winding continuity
3Replace fan motor if continuity fails

E010

Door Lock Fault

Door lock not confirming position during self-clean cycle

Medium Priority

Possible Causes
Lock motor failed
Mechanical obstruction in latch path
Wiring to lock open
Diagnostic Steps
1Check latch for obstruction
2Test lock motor continuity
3Replace lock assembly if motor failed

E011

Control Board Fault

Control board internal fault detected — oven will not operate

High Priority

Possible Causes
Board component failure due to heat
Power surge damage
Diagnostic Steps
1Disconnect power 60 seconds and retry
2Inspect board for burn marks
3Replace control board if fault persists

E031

Self-Clean Overtemp

Oven exceeded maximum temperature limit during self-clean cycle

Urgent

Possible Causes
Self-clean cycle ran too long without stopping
Temperature sensor reading incorrectly — heater running unregulated
Diagnostic Steps
1Allow oven to cool completely before servicing
2Test temperature sensor for accurate reading
3Replace sensor and verify control board relay operation

Need a Technician in Miami or Hialeah?

AppliancesCare provides same-day Bosch oven & stove repair across Miami-Dade. Bilingual service — English & Spanish.

📞 Call (786) 587-0722

Important Notice: Error code information on this page is based on Bosch manufacturer service documentation. Oven and range repair involves high-voltage components. Gas appliances require licensed gas technician service. Temperature sensor values are typical — verify against your model documentation. AppliancesCare Appliance Repair LLC provides this information for educational purposes only.