Dacor Dishwasher Error Codes

Found Your Error Code?

Our technicians serve Miami, Hialeah, Doral, and surrounding areas — same day. Call now for fast diagnosis and repair.

📋 Error Code Index — Dacor Dishwasher

E1Fill Timeout E3Heating Fault E9Door Latch Fault

Fill Timeout

Appliance did not reach required water level within allowed fill time.

Medium Priority

Possible Causes
Water supply valve closed or restricted
Inlet valve solenoid failed
Low household water pressure below 20 psi
Inlet screen clogged with mineral deposits
Diagnostic Steps
1Verify supply valve fully open
2Check household water pressure
3Clean inlet valve screen
4Test inlet valve solenoid and replace if failed

Heating Fault

Water not reaching required temperature within allowed time.

Medium Priority

Possible Causes
Heating element failed open circuit
NTC temperature sensor faulty
Control board relay not energizing heater
Diagnostic Steps
1Test heating element — OL confirms open circuit
2Test NTC sensor resistance at room temperature
3Replace heating element or NTC sensor as indicated

Door Latch Fault

Door not confirmed closed — cycle cannot start or is interrupted.

Medium Priority

Possible Causes
Door not fully closed
Door latch microswitch failed
Latch hook or strike damaged
Diagnostic Steps
1Push door firmly closed — listen for audible click
2Inspect latch hook and strike for damage
3Test door microswitch continuity and replace if failed

Need a Technician in Miami or Hialeah?

AppliancesCare provides same-day Dacor dishwasher repair across Miami-Dade. Bilingual service — English & Spanish.

📞 Call (786) 587-0722

Important Notice: Error code information on this page is based on Dacor manufacturer service documentation. Always disconnect power and water supply before inspecting. Fault behavior may vary by model year. AppliancesCare Appliance Repair LLC provides this information for educational purposes only.