Fisher & Paykel Oven & Stove Error Codes

Found Your Error Code?

Our technicians serve Miami, Hialeah, Doral, and surrounding areas — same day. Call now for fast diagnosis and repair.

📋 Error Code Index — Fisher & Paykel Oven & Stove

F1Control Board Failure F3Oven Temperature Sensor Open F4Oven Temperature Sensor Short F7Door Lock Fault F8Cooling Fan Fault F9Self-Clean Overtemp

Control Board Failure

Main control board detected an internal fault — oven will not operate.

High Priority

Possible Causes
Control board component failure
Power surge damage
Diagnostic Steps
1Disconnect power 60 seconds and retry
2Inspect board for burn marks
3Replace main control board if fault persists

Oven Temperature Sensor Open

RTD probe open circuit — oven cannot monitor temperature.

Medium Priority

Possible Causes
RTD probe failed open internally
Connector loose or corroded
Probe wiring open
Diagnostic Steps
1Test probe resistance — ~1080Ω at room temperature
2OL reading confirms failed probe
3Reseat connector before replacing
4Replace sensor if open confirmed

Oven Temperature Sensor Short

RTD probe shorted — incorrect temperature reading.

Urgent

Possible Causes
RTD probe failed shorted
Probe wiring touching oven cavity metal
Diagnostic Steps
1Test probe — near 0Ω confirms short
2Inspect probe wiring
3Replace sensor — do not operate until repaired

Door Lock Fault

Door lock not confirming position during self-clean cycle.

Medium Priority

Possible Causes
Lock motor failed
Mechanical obstruction in latch path
Wiring to lock open
Diagnostic Steps
1Check latch for physical obstruction
2Test lock motor continuity
3Replace lock assembly if motor failed

Cooling Fan Fault

Cooling fan not operating — overheating risk to control electronics.

High Priority

Possible Causes
Fan motor failed or seized
Wiring to fan open
Fan blade obstructed
Diagnostic Steps
1Check fan blade for obstruction
2Test fan motor winding continuity
3Replace cooling fan motor if failed

Self-Clean Overtemp

Oven temperature exceeded maximum safe limit during self-clean cycle.

Urgent

Possible Causes
Self-clean cycle ran without shutting off
Temperature sensor reading incorrectly — heater running unregulated
Control board relay fault
Diagnostic Steps
1Allow oven to cool completely before servicing
2Test temperature sensor accuracy
3Replace sensor and verify control board relay operation

Need a Technician in Miami or Hialeah?

AppliancesCare provides same-day Fisher & Paykel oven & stove repair across Miami-Dade. Bilingual service — English & Spanish.

📞 Call (786) 587-0722

Important Notice: Error code information on this page is based on Fisher & Paykel manufacturer service documentation. Oven repair involves high-voltage components. Gas appliances require licensed gas technician service. AppliancesCare Appliance Repair LLC provides this information for educational purposes only.