Whirlpool Washer Error Codes

Found Your Error Code?

Our technicians serve Miami, Hialeah, Doral, and surrounding areas — same day. Call now for fast diagnosis and repair.

📋 Error Code Index — Whirlpool Washer

F01Main Control Board Failure F06Drive Motor Fault F11Serial Communication Error F21Long Drain Time F35Analog Pressure Sensor Failure F5E1Door Switch Fault SUDExcess Suds Detected

F01

Main Control Board Failure

Main electronic control board detected an internal fault.

High Priority

Possible Causes
Control board component failure due to age or heat
Power surge damage
Diagnostic Steps
1Disconnect power 60 seconds and retry
2Inspect board for burn marks
3Replace main control board if fault persists

F06

Drive Motor Fault

Drive motor not starting or failing during spin cycle.

High Priority

Possible Causes
Drive motor failed
Motor control board fault
Drive belt broken
Diagnostic Steps
1Check drive belt condition
2Test motor winding continuity
3Replace motor or control board as indicated

F11

Serial Communication Error

Communication fault between main and motor control boards.

High Priority

Possible Causes
Wiring harness loose between boards
Motor control board failed
Main control board failed
Diagnostic Steps
1Check wiring harness connections at both boards
2Power cycle unit 60 seconds
3Replace motor control or main board as indicated

F21

Long Drain Time

Washer did not drain within allowed time — water remaining in drum.

Medium Priority

Possible Causes
Drain pump filter blocked with debris
Drain hose kinked
Drain pump motor failed
Diagnostic Steps
1Clean drain pump filter — remove all lint, coins, debris
2Check drain hose for kinks and proper routing
3Test drain pump motor and replace if failed

F35

Analog Pressure Sensor Failure

Water level pressure sensor reading outside expected range.

Medium Priority

Possible Causes
Pressure sensor failed internally
Pressure hose kinked or disconnected
Air dome on tub blocked with detergent residue
Diagnostic Steps
1Check pressure hose connections
2Clear blockage from air dome port
3Test pressure sensor and replace if out of range

F5E1

Door Switch Fault

Door switch not confirming closed — cycle cannot start.

Medium Priority

Possible Causes
Door not fully closed or latching correctly
Door switch failed internally
Wiring to door switch open
Diagnostic Steps
1Push door firmly closed — listen for latch click
2Inspect latch and strike for damage
3Test door switch and replace if open when closed

SUD

Excess Suds Detected

Excessive suds detected — cycle paused to allow suds to dissipate.

Low Priority

Possible Causes
Non-HE detergent used in HE washer
Too much HE detergent per load
Detergent residue buildup in dispenser
Diagnostic Steps
1Use only HE-rated detergent
2Reduce detergent quantity
3Run Rinse & Spin cycle to clear suds
4Clean dispenser drawer regularly

Need a Technician in Miami or Hialeah?

AppliancesCare provides same-day Whirlpool washer repair across Miami-Dade. Bilingual service — English & Spanish.

📞 Call (786) 587-0722

Important Notice: Error code information on this page is based on Whirlpool manufacturer service documentation. Always disconnect power and water supply before inspecting internal components. AppliancesCare Appliance Repair LLC provides this information for educational purposes only.