Crosley Washer Error Codes

Found Your Error Code?

Our technicians serve Miami, Hialeah, Doral, and surrounding areas — same day. Call now for fast diagnosis and repair.

📋 Error Code Index — Crosley Washer

F01Main Control Board Failure F21Long Drain Time F35Analog Pressure Sensor Failure F5E1Door Switch Fault SUDExcess Suds Detected

F01

Main Control Board Failure

Main electronic control board detected an internal fault.

High Priority

Possible Causes
Control board component failure due to age or heat
Power surge damage to board circuitry
Diagnostic Steps
1Disconnect power 60 seconds and retry
2Inspect board for visible burn marks
3Replace main control board if fault persists

F21

Long Drain Time

Washer did not drain within allowed time — water remaining in drum.

Medium Priority

Possible Causes
Drain pump filter blocked with debris — most common cause
Drain hose kinked or incorrectly routed
Drain pump motor failed
Diagnostic Steps
1Clean drain pump filter — remove all lint, coins, debris
2Check drain hose for kinks and proper routing
3Test drain pump motor continuity and replace if failed

F35

Analog Pressure Sensor Failure

Water level analog pressure sensor reading outside expected range.

Medium Priority

Possible Causes
Pressure sensor failed internally
Pressure hose kinked or disconnected
Air dome on tub blocked with detergent residue
Diagnostic Steps
1Check pressure hose connection at sensor and tub air dome
2Clear any blockage from air dome port
3Test pressure sensor and replace if reading is out of range

F5E1

Door Switch Fault

Door switch not confirming closed position — cycle cannot start.

Medium Priority

Possible Causes
Door not fully closed or latching correctly
Door switch failed internally
Wiring to door switch open or damaged
Diagnostic Steps
1Push door firmly closed — listen for latch click
2Inspect latch and strike for damage or misalignment
3Test door switch continuity — replace if open when door is closed

SUD

Excess Suds Detected

Excessive suds in drum — cycle paused to allow suds to dissipate.

Low Priority

Possible Causes
Non-HE detergent used in HE washer
Too much HE detergent used per load
Detergent residue buildup in dispenser drawer
Diagnostic Steps
1Use only HE-rated detergent
2Reduce detergent quantity
3Run a Rinse & Spin cycle to clear suds
4Clean detergent dispenser drawer regularly

Need a Technician in Miami or Hialeah?

AppliancesCare provides same-day Crosley washer repair across Miami-Dade. Bilingual service — English & Spanish.

📞 Call (786) 587-0722

Important Notice: This reference is undergoing technical review. Confirm all codes in the manual for your exact model. Always disconnect power and water supply before inspecting. Fault behavior may vary by model and production date. AppliancesCare Appliance Repair LLC provides this information for educational purposes only.