GE Oven & Stove Error Codes

Found Your Error Code?

Our technicians serve Miami, Hialeah, Doral, and surrounding areas — same day. Call now for fast diagnosis and repair.

📋 Error Code Index — GE Oven & Stove

F0Stuck Key F2Oven Temperature Runaway F3Oven Temperature Sensor Open F4Oven Temperature Sensor Short F7Stuck Key F8Door Lock Fault F9Door Lock Failure During Clean

Stuck Key

A key on the membrane panel is continuously activated.

Medium Priority

Possible Causes
Moisture on keypad
Physical damage to membrane keypad
Debris under keypad
Diagnostic Steps
1Dry keypad with clean cloth
2Press Cancel to reset
3Disconnect power 60 seconds
4Replace control panel if fault persists

Oven Temperature Runaway

Oven temperature exceeded maximum safe limit.

Urgent

Possible Causes
Temperature sensor shorted — false low reading causing overrun
Control board relay welded closed — heater running unregulated
Diagnostic Steps
1Disconnect power immediately
2Test temperature sensor — near 0Ω confirms short
3Replace sensor and verify relay before reuse

Oven Temperature Sensor Open

RTD probe open circuit — oven cannot monitor temperature.

Medium Priority

Possible Causes
RTD probe failed open
Connector loose or corroded
Probe wiring open
Diagnostic Steps
1Test probe resistance — ~1080Ω at room temperature
2OL reading confirms failed probe
3Reseat connector before replacing
4Replace sensor if open confirmed

Oven Temperature Sensor Short

RTD probe shorted — incorrect temperature reading.

Urgent

Possible Causes
RTD probe failed shorted
Probe wiring touching cavity metal
Diagnostic Steps
1Test probe — near 0Ω confirms short
2Inspect probe wiring
3Replace sensor — do not operate until repaired

Stuck Key

A key on the membrane panel is continuously activated or shorted.

Medium Priority

Possible Causes
Moisture on keypad
Physical damage to membrane
Debris under surface
Diagnostic Steps
1Dry keypad with clean cloth
2Press Cancel to reset
3Disconnect power 60 seconds
4Replace control panel if fault persists

Door Lock Fault

Door lock not confirming position during self-clean cycle.

Medium Priority

Possible Causes
Lock motor failed
Mechanical obstruction in latch path
Wiring to lock open
Diagnostic Steps
1Check latch for obstruction
2Test lock motor continuity
3Replace lock assembly if motor failed

Door Lock Failure During Clean

Door locked but self-clean did not complete — lock cannot release.

Medium Priority

Possible Causes
Lock motor failed in locked position
Control board fault — not sending unlock signal
Mechanical jam in lock mechanism
Diagnostic Steps
1Allow oven to cool completely — lock may release automatically
2Disconnect power 5 minutes and retry
3Replace lock assembly if motor confirmed failed

Need a Technician in Miami or Hialeah?

AppliancesCare provides same-day GE oven & stove repair across Miami-Dade. Bilingual service — English & Spanish.

📞 Call (786) 587-0722

Important Notice: Error code information on this page is based on GE manufacturer service documentation. Oven repair involves high-voltage components. Gas appliances require licensed gas technician service. AppliancesCare Appliance Repair LLC provides this information for educational purposes only.