Electrolux Dishwasher Error Codes

Found Your Error Code?

Our technicians serve Miami, Hialeah, Doral, and surrounding areas — same day. Call now for fast diagnosis and repair.

📞 Call (786) 587-0722

📋 Error Code Index — Electrolux Dishwasher

i10Water Intake Fault i20Water Drain Fault i30Water Leak / Overflow i50Circulation Pump Fault i60Heating Fault

i10

Water Intake Fault

Appliance not filling to required level within allowed time.

Medium Priority

Possible Causes
Water supply valve closed or restricted
Inlet valve solenoid failed
Low water pressure below 20 psi
Inlet screen clogged with mineral deposits
Diagnostic Steps
1Verify supply valve fully open
2Check household water pressure
3Clean inlet valve screen
4Test inlet valve solenoid and replace if failed

i20

Water Drain Fault

Appliance not draining within allowed time.

Low Priority

Possible Causes
Drain pump filter blocked with food debris
Drain hose kinked or incorrectly routed
Drain pump motor failed
Diagnostic Steps
1Remove and clean drain pump filter
2Check drain hose for kinks
3Test drain pump motor continuity and replace if failed

i30

Water Leak / Overflow

Aqua-stop float switch triggered — water detected in base tray.

Urgent

Possible Causes
Inlet valve stuck open — not closing after fill
Door seal damaged — leaking during cycle
Hose connection loose internally
Diagnostic Steps
1Disconnect power and water immediately
2Tilt appliance forward to drain base tray
3Inspect door seal and hose connections
4Test inlet valve — replace if passing water when off

i50

Circulation Pump Fault

Wash circulation pump not operating correctly — no wash pressure.

High Priority

Possible Causes
Circulation pump impeller blocked by debris
Pump motor failed
Wiring to pump open
Diagnostic Steps
1Check pump impeller for debris obstruction
2Test pump motor winding continuity
3Replace circulation pump if motor confirmed failed

i60

Heating Fault

Water not reaching required temperature within allowed time.

Medium Priority

Possible Causes
Heating element failed open circuit
NTC temperature sensor faulty
Control board relay not energizing heater
Diagnostic Steps
1Test heating element — OL confirms open circuit
2Test NTC sensor resistance at room temperature
3Replace heating element or NTC sensor as indicated

Need a Technician in Miami or Hialeah?

AppliancesCare provides same-day Electrolux dishwasher repair across Miami-Dade. Bilingual service — English & Spanish.

📞 Call (786) 587-0722

Important Notice: Error code information on this page is based on Electrolux manufacturer service documentation. Always disconnect power and water supply before inspecting. Fault behavior may vary by model year. AppliancesCare Appliance Repair LLC provides this information for educational purposes only.