Electrolux Oven & Stove Error Codes

Found Your Error Code?

Our technicians serve Miami, Hialeah, Doral, and surrounding areas — same day. Call now for fast diagnosis and repair.

📋 Error Code Index — Electrolux Oven & Stove

F11Oven Temperature Sensor Open F12Oven Temperature Sensor Short F13Oven Control Fault F30Probe Not Installed F42Cooling Fan Fault F50Door Lock Fault

F11

Oven Temperature Sensor Open

RTD probe detected as open circuit — oven cannot monitor temperature.

Medium Priority

Possible Causes
RTD probe failed open internally
Connector loose or corroded
Probe wiring open circuit
Diagnostic Steps
1Test probe resistance — ~1080Ω at room temperature
2OL reading confirms failed probe
3Reseat connector before replacing
4Replace oven temperature sensor if open confirmed

F12

Oven Temperature Sensor Short

RTD probe shorted — control receiving incorrect temperature reading.

Urgent

Possible Causes
RTD probe failed shorted internally
Probe wiring shorting to oven cavity metal
Diagnostic Steps
1Test probe — near 0Ω confirms short
2Inspect probe wiring for contact with cavity
3Replace sensor — do not operate oven until repaired

F13

Oven Control Fault

Control board internal fault affecting temperature regulation.

High Priority

Possible Causes
Control board component failure
Power surge damage
Diagnostic Steps
1Disconnect power 60 seconds and retry
2Inspect board for burn marks
3Replace control board if fault persists

F30

Probe Not Installed

Meat probe jack shorting — probe not inserted correctly or jack has debris.

Medium Priority

Possible Causes
Probe jack shorted by liquid or food debris
External probe failed shorted
Nothing inserted but jack is registering signal
Diagnostic Steps
1Inspect probe jack for debris or liquid
2Remove probe and clean jack thoroughly
3Replace probe or probe jack as indicated

F42

Cooling Fan Fault

Cooling fan not operating — overheating risk to control electronics.

High Priority

Possible Causes
Fan motor failed or seized
Wiring to fan motor open
Fan blade obstructed by debris
Diagnostic Steps
1Check fan blade for obstruction
2Test fan motor winding continuity
3Replace cooling fan motor if failed

F50

Door Lock Fault

Door lock not confirming position during self-clean cycle.

Medium Priority

Possible Causes
Lock motor failed
Mechanical obstruction in latch path
Wiring to lock assembly open
Diagnostic Steps
1Check latch for physical obstruction
2Test door lock motor winding continuity
3Replace lock assembly if motor confirmed failed

Need a Technician in Miami or Hialeah?

AppliancesCare provides same-day Electrolux oven & stove repair across Miami-Dade. Bilingual service — English & Spanish.

📞 Call (786) 587-0722

Important Notice: Error code information on this page is based on Electrolux manufacturer service documentation. Oven repair involves high-voltage components. Gas appliances require licensed gas technician service. AppliancesCare Appliance Repair LLC provides this information for educational purposes only.