Electrolux Washer Error Codes

Found Your Error Code?

Our technicians serve Miami, Hialeah, Doral, and surrounding areas — same day. Call now for fast diagnosis and repair.

📞 Call (786) 587-0722

📋 Error Code Index — Electrolux Washer

E11Water Inlet Fault E21Drain Fault E31Pressure Switch Fault E41Door Lock Fault E51Motor Fault E91Communication Fault

E11

Water Inlet Fault

Washer not filling with water within allowed time.

Medium Priority

Possible Causes
Supply valves closed or restricted
Inlet valve solenoid failed
Low water pressure
Inlet hose screens clogged
Diagnostic Steps
1Verify both supply valves fully open
2Check water pressure — minimum 20 psi
3Clean inlet hose screens
4Test inlet valve and replace if failed

E21

Drain Fault

Washer not draining within allowed time.

Medium Priority

Possible Causes
Drain pump filter blocked
Drain hose kinked
Drain pump motor failed
Diagnostic Steps
1Clean drain pump filter
2Check drain hose for kinks
3Test drain pump motor and replace if failed

E31

Pressure Switch Fault

Water level pressure switch reading outside expected range.

Medium Priority

Possible Causes
Pressure switch failed internally
Pressure hose kinked or disconnected
Air dome blocked with detergent residue
Diagnostic Steps
1Check pressure hose connections
2Clear blockage from air dome port
3Test pressure switch and replace if out of range

E41

Door Lock Fault

Door lock not confirming position — cycle cannot start or continue.

Medium Priority

Possible Causes
Door not fully closed
Lock actuator failed
Wiring to lock open
Diagnostic Steps
1Push door firmly closed
2Inspect latch for damage
3Test lock actuator and replace if failed

E51

Motor Fault

Drive motor not starting or failing during spin cycle.

High Priority

Possible Causes
Drive motor failed
Motor control board fault
Drive belt broken
Diagnostic Steps
1Check drive belt condition
2Test motor winding continuity
3Replace motor or control board as indicated

E91

Communication Fault

Communication error between main board and motor control board.

High Priority

Possible Causes
Wiring harness loose between boards
Motor control board failed
Main control board failed
Diagnostic Steps
1Check wiring harness connections at both boards
2Power cycle unit 60 seconds
3Replace motor control or main board as indicated

Need a Technician in Miami or Hialeah?

AppliancesCare provides same-day Electrolux washer repair across Miami-Dade. Bilingual service — English & Spanish.

📞 Call (786) 587-0722

Important Notice: Error code information on this page is based on Electrolux manufacturer service documentation. Always disconnect power and water supply before inspecting internal components. AppliancesCare Appliance Repair LLC provides this information for educational purposes only.